First for the base, we used an 8′ 2×4 cut in half. A groove was made in the center of both boards wide enough that they would be able to interlock. This joint was then glued; clamping allowed the glue to dry. Once the glue has dried, a hole was cut in the center of this X with an outside diameter the same as the PVC pipe of the tree (we used 2″ PVC, which has a slightly larger outside diameter). Holes are then drilled in the 2×4 toward the ends of the X to allow a 1/2″ piece of rebar to hold the base down. This X will receive a coat of primer and a coat of hunter green paint before Christmas to protect it from the elements.

Rebar stakes were made by cutting pieces of rebar, then heating it up until it would bend into a 90-degree angle (L-shape). These will be used to hold the base to the ground. Obviously it would be advisable to first check on any underground utilities that these stakes could strike!

The tree-topper is more complicated. We started with a drain plumbing fixture designed to be used with 2″ PVC (also compatible with 3″). 4 holes were drilled around the middle section of the pipe to fasten eye-bolts to the fixture. Wire rope will be used with these eye-bolts to guy wire the tree (stabilizes the tree and prevents problems with wind). We then take apart the top part of the plumbing fixture; removing the threaded drain and loosening the bolts holding the fixture’s threaded side on. A 3/4″ piece of wood is then cut in a circle shape with another circle cut inside of that to allow the threaded drain to be used. Longer bolts from the hardware store and holes drilled in the piece of wood will then allow the fixture to come together. Hooks can be screwed into the wood around the circle to hold strings of lights (I zip tie light strings to parachute cord so that the parachute cord holds the tension). The threaded drain can be used to mount a star (or other object) to top the tree.

I found this calculator to be useful!

Pictures are worth a thousand words each! Here is four: